• Numato 8 Channel Bluetooth Relay Module

    Numato 8 Channel Bluetooth Relay Module

    76,90 

    8 Channel Bluetooth Relay Module is great for controlling your devices over Bluetooth link without any RF design knowledge. This module is designed to plug in to your design seamlessly. Individual relay can be controlled by simple commands. Numato’s 8 Channel Bluetooth Relay Module provides exceptional value for money.

  • Numato 8 Channel Ethernet Relay Module

    Numato 8 Channel Ethernet Relay Module

    105,20 

    Numato Lab 8 Channel Ethernet Relay module allows controlling electrical devices remotely through Ethernet. This is very helpful in those situations where the device that needs to be controlled is located far from the PC and thus can not run USB cable. Numato Lab Ethernet Relay modules are designed to be very easy to setup and use. This product has 8 on board relays and 10 GPIOs. Each relay/gpio can be individually controlled through the built in easy to use web interface or through any popular terminal emulator that supports TELNET protocol.

  • Numato 8 Channel Relay Controller Board

    Numato 8 Channel Relay Controller Board

    Numato 8 Relay breakout module is a smart choice for controlling higher current loads from your microcontroller development board, PC parallel port or your favourite Arduino. This board has eight on-board relays which can switch up to 10A. All relay terminals (C, NC, NO) are accessible through screw terminals which makes wiring up the board very easy. The relays are driven by popular darlington array ULN2803. Relay coil is rated for 12VDC.

    Features

    • Very compact and easy to wire up
    • 1.6mm FR4 PCB with Green solder mask and white silk screen
    • Connects directly to TTL devices (Microcontrollers, Arduino etc..)
    • Eight Relays with three pin screw terminals for easy connectivity

    Applications

    • Home Automation
    • Industrial Automation
    • Lighting Control
    • Garden Equipment Control
    • Test Fixtures
    • DIY and Hobby
  • Numato LM317 Variable Voltage Regulator Breakout

    Numato LM317 Variable Voltage Regulator Breakout

    5,90 

    Compact, easy to use LM317 variable voltage regulator breakout board. Screw terminal for input and output.

  • Numato Opto Isolator Breakout - PC817

    Numato Opto Isolator Breakout – PC817

    14,50 

    Opto isolation can be very helpful in protecting your sensitive devices such as microcontrollers and FPGAs from noise and higher voltages present when using Motors, Relays and other actuators. When prototyping on a bread board, it can be a real hassle wiring up everything and the circuit can end up looking like a rat’s nest. This breakout board helps to add opto isolation to any circuit with minimum amount of wiring.

  • Numato USB Multi Voltage Power Supply

    Numato USB Multi Voltage Power Supply

    10,50 

    Numato Lab’s USB Multi Voltage Supply Module is a versatile product which can power other circuits from a USB port. This board has 4 different voltage outputs. It can accept power from USB or using an external connector. There are four voltage regulators which provide output voltages 5V, 3.3V, 2.5V & 1.2V. Onboard screw terminals makes it easy to attach external circuits to this board.

  • One load relay board 5A

    One load relay board 5A

    7,30 

    The board has one Load relay with two connectors. If 12V are connected to the left board connector, the relay will Turn ON. On the right connector is leaded normal open contact of the relay: Rel NO. The used relay is Omron G6D-1A-ASI DC 12, with max to 5A current of the contacts;

  • One load relay board 8A

    One load relay board 8A

    8,60 

    The board has one Load relay with two connectors. If 12V are connected to the left board connector, the relay will Turn ON. The right connector has three screws: – COM – common; – NC – normal closed contact; – NO – normal open contact; The used relay is Omron G2RL-2 DC12, with max to…

  • PC Restarter

    PC Restarter

    24,60 

    The board will help you increase the reliability of your computer system to infinity. This means your computer will never stop! A controlled from the computer pulsing signal has to be connected to the digital input of the board Pulse. The board has two relays. One relay is powerful and its normally closed contact is…

  • PRB-0.6-7 Temperature sensor (Termistor) -40..+120 [°C] + 10k 1% resistor

    PRB-0.6-7 Temperature sensor (Termistor) -40..+120 [°C] + 10k 1% resistor

    7,90 

    Video demos: An experiment with PRB-0.6-7 0.6 temperature sensor and AltonaLab SCADA software: https://www.youtube.com/watch?v=ESIqgjoEwhw The Probe Temperature Sensor is located inside a 0.6″ Stainless Steel cylinder. It is a 10K Thermistor, with an industry standard Type 2 curve. Connected to the end of the Sensor is 2 UL2468 26/2CAWG 105°C Black Wires with tinned ends….

  • Pressure sensor module MPS20N0040D-D Output: mV signal

    Pressure sensor module MPS20N0040D-D Output: mV signal

    4,50 

    Features & Specifications Application areas: Automotive: tire pressure, car air pump, MAP sensor, diagnostic equipment, automotive sensors. Industry: Air brake switch, portable pressure gauge, such as digital pressure gauge, environmental monitoring, consumer and sports Health care: patient monitoring and diagnostic equipment, such as blood pressure monitors, medical instrumentation and monitoring Pressure range of 580 PSIG,…

  • PWM Regulator with digital input starter

    PWM Regulator with digital input starter

    10,90 

    The board is simple to use and can control powerful load in range 0..100%. If the Jumper located on the board is removed, the load will receive 0..50% of the power supply of the board. The load power can be regulated with the potentiometer on the board. To Turn ON the board – just set…

  • Saturn - Spartan 6 FPGA Development Board with DDR SDRAM

    Saturn – Spartan 6 FPGA Development Board with DDR SDRAM

    116,90 

    Please note, the device is: XC6SLX16

    IO Headers: Installed On Board

    Header Type: Female Header

     

    Saturn is an easy to use FPGA Development board featuring Xilinx Spartan-6 FPGA. Saturn is specially designed for experimenting and learning system design with FPGAs. This development board features Xilinx XC6SLX series FPGA with FTDI’s FT2232H Dual-Channel USB device. The high speed USB 2.0 interface provides fast and easy configuration download to the on-board SPI flash. No programmer or special downloader cable is needed to download the bit stream to the board.

  • Silicon electronic heater 12V 10W

    Silicon electronic heater 12V 10W

    2,10 

    Silicon electronic heater 12V 10W

  • SNMP Controller 24 IO

    SNMP Controller 24 IO

    33,90 

    The board is very powerful and fast and can be used for many purposes. The board power supply is 12V. The board has three ports. Each of the eight pins of the Port P3 and Port P5 can be set as digital inputs or outputs. Port P6 has eight pins too, but they can be…

  • Snow Raindrops Humidity Weather Detect Sensor Module

    Snow Raindrops Humidity Weather Detect Sensor Module

    7,90 

    Description: The sensor is suitable for robot kit, raindrops, rain sensor, monitoring can be used for a variety of weather conditions, and converted into the number of the reference signal and the AO output. The sensor uses the FR-04 high-quality double-sided materials, King Size 5.0 * 4.0CM, and with the surface of the nickel plating…