All prices are final and additional VAT will not be charged.

Showing 25–32 of 82 results

  • Mimas V2 Spartan 6 FPGA Development Board with DDR SDRAM


    MIMAS V2 is a feature packed yet low cost FPGA Development board featuring Xilinx Spartan-6 FPGA. MIMAS V2 is specially designed for experimenting and learning system design with FPGAs. This development board features SPARTAN XC6SLX9 CSG324 FPGA with onboard 512Bb DDR SDRAM. The USB 2.0 interface provides fast and easy configuration download to the on-board SPI flash. No need to buy an expensive programmer or special downloader cable to download the bit stream to the board.

  • MUC Alarm sensor


    MUC Alarm sensor – Door Or Window Contact Magnetic Reed Switch Alarm

  • Numato 1 Channel USB Powered Relay Module


    1 Channel USB Powered Relay Module is great for controlling your devices through USB without any USB protocol knowledge. This modules plugs in to your design seamlessly. Individual relays can be controlled by simple commands. The relays are powered from USB bus so it is important to connect this board directly to a PC or to a powered hub. Numato’s 1 Channel USB Powered Relay Module provides exceptional value for money.

  • Numato 16 Channel Ethernet GPIO Module With Analog Inputs


    Numato’s 16 Channel Ethernet GPIO module is low cost easily deployable solution for connecting your PC to other electronic circuitry through network. This GPIO module can be accessed through a simple web interface or Telnet.

  • Numato 16 Channel Ethernet Relay Module


    Numato Lab 16 Channel Ethernet Relay module allows controlling electrical devices remotely through Ethernet. This is very helpful in those situations where the device that needs to be controlled is located far from the PC and thus can not run USB cable. Numato Lab Ethernet Relay modules are designed to be very easy to setup and use. This product has 16 on board relays and 8 GPIOs. Each relay/gpio can be individually controlled through the built in easy to use web interface or through any popular terminal emulator that supports TELNET protocol. All GPIOs can be used as analog inputs (10 bits resolution) as well.

  • Numato 16 Channel Relay Controller Board


    Numato 16 Relay breakout module is a smart choice for controlling higher current loads from your microcontroller development board, PC parallel port or your favourite Arduino. This board has sixteen on-board relays which can switch up to 10A. All relay terminals (C, NC, NO) are accessible through screw terminals which makes wiring up the board very easy. The relays are driven by popular darlington array ULN2803. Relay coil is rated for 12VDC.